Dear Experts,

i have only software program(No hardware configuration) which is developed in Simatic manager.

out input pin get damaged, i found one spare input, to use that pin i want to change address as new.

will it work? 

Thanks,

arslan

Hi ara12,

Use the spare input & make connections.

U can use rewire function to automatically replace old ip address with new address. See attachment.

Thanks experts,

i do, and will let you know the status.

ars12

Dear Experts,

I tried to rewire as you said but it show the error message, please see attached screenshot,

Thanks,

ara12

Hi ara12,

The project appears to be not consistent or not organized.

Perform 'check block consistency'.

Dear Sachin,

I tried "check block consistency" but here also i faced problem, see attached pic1&2,

is it possible that i goto specific FC and change the address only there, see pic03

As I20.3 is using only in FC20 at NW01 to I20.6(which is spare) save and download only changes?

Thanks 

ara12

ara12

I tried "check block consistency" but here also i faced problem, see attached pic1&2,

is it possible that i goto specific FC and change the address only there, see pic03

As I20.3 is using only in FC20 at NW01 to I20.6(which is spare) save and download only changes?

 The compiler is giving a warning that you don't have the correct software package to compile some blocks.

If the old input is used only once in the program, then change it directly in the FC and download the FC to the PLC.

Thanks dear All,

its done by changing the the address in FC only,

Regards,

ara12