Hi.Sorry for my dealy in the response, but it was for personal matters.

Thank you very much.

i'll try and say the result.

New question published by Jay Hind is split to a separate thread with the subject Can I control speed and Torque by LOGO PLC PWM output?.

Best regards
Jen_Moderator

Hi.

Finally I can go to the installation and test it again on the field. But the problem persist with the new program. 

In teh picture attache you can see the problem I have with the SP conditioner Bloc.

When I make a simulation the value for Ax in the SP Conditioning blok is the corret, 15, but wen I did the online test the Ax Value in the block SP Conditioning always takes the value of the offset programed in this bloc, 45, and is not correct.

Mybe I do sonthing stupid that I can not see, but I'm nearly madness with this problem, because the in put of the PI Controler  is not correct and the watter flow temperature never cahnges with the outside temperature.

Thank you very much, for your help.

Sorry I forgot the picture for the simulation.

Thanks

In the attachment a sample for a Wetherdependant value

You can use it, place a PI reg Block  as setpiont to the output of B004 (instead of AM3).

Hopes this helps