Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

What is the EP terminal used for?

Created by: AutoGen_2416010 at: 11/17/2023 7:15 AM (2 Replies)

Rating (0)

Thanks 2

3 Entries

11/17/2023 7:15 AM	Rate (0)
AutoGen_2416010 Joined: 11/17/2023 Last visit: 11/23/2023 Posts: 3 Rating: (0)	Hello, I'm working on a Siemens CUA32. I couldn't grasp the purpose of the EP terminals in X210. Could you explain to me what this EP terminal is used for? Thank you.

Suggestion To thank Quote Answer

11/17/2023 10:13 AM	Rate (0)
jacek d Platinum Member Joined: 9/23/2005 Last visit: 11/15/2024 Posts: 4793 Rating: (733)	EP stands for Enable Pulses. It takes part in Safety Integrated Basic Functions STO. Manual, chapter 6.
	Regards, Jacek What is confusing you is the fact that you never see a number but always its digit representation. So you end up thinking that the number is the representation. - Andrej Bauer Any claims against me - based on whatever legal reason - resulting from the use of any code and/or ideas presented on this forum shall be excluded. #StayWithUkraine
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users AutoGen_2416010

11/23/2023 8:08 AM	Rate (0)
AutoGen_2416010 Joined: 11/17/2023 Last visit: 11/23/2023 Posts: 3 Rating: (0)	Thank You

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users jacek d

|

Share this page:

Share this page on...

Follow us on