Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

How should write the command in the SMS to activate/desactivate my digital imput 1?

Created by: AutoGen_7470129 at: 5/20/2024 4:26 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

5/20/2024 4:26 PM	Rate (0)
AutoGen_7470129 Joined: 5/20/2024 Last visit: 5/20/2024 Posts: 2 Rating: (0)	Hi, i am having a problem quite similar i think, maybe someone could help me. I am using a LOGO CMR 2020 with a logo BM 8. If i want to access the digital imput 1 of my program loaded in the BM using the command attached in the screenshot, how should i write the command in the SMS to activate/desactivate my digital imput 1? Thank you everyone, hope someone can help me ------------------------------------------------------------------------------------------ Split from VM numbers and types in the LOGO BM. Attachment command.png (152 Downloads)
	Last edited by: Jen_Moderator at: 05/21/2024 04:50:41 New subject after splitting
Suggestion To thank Quote Answer

5/20/2024 5:57 PM	Rate (0)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 11/6/2024 Posts: 34151 Rating: (4254)	U_bdb16d2c-b902-4329-8e55-efc127f99c90 Hi, i am having a problem quite similar i think, maybe someone could help me. I am using a LOGO CMR 2020 with a logo BM 8. If i want to access the digital imput 1 of my program loaded in the BM using the command attached in the screenshot, how should i write the command in the SMS to activate/desactivate my digital imput 1? Thank you everyone, hope someone can help me You don't have a similar problem, your problem is of a completely different nature. You cannot activate or deactivate a digital input of a base module. The program only looks at the state of the hardware of the digital input. This means that you can only look at the status of the digital input from the CMR.

Suggestion To thank Quote Answer

5/20/2024 6:51 PM	Rate (0)
AutoGen_7470129 Joined: 5/20/2024 Last visit: 5/20/2024 Posts: 2 Rating: (0)	Hi. First of all, thank you for your answer. So, in case I want to control the value of a digital input or output (I / O) in my logo BM 8 sending SMS. How should I configure it in the program with Logosoft comfort or in the CMR? The command I think I should use in the sms is the one attached. Please, tell me if I am wrong. Thank you in advance. Attachment Captura de Pantalla 2024-05-20 a las 20.48.00.png (129 Downloads)
	Last edited by: U_bdb16d2c-b902-4329-8e55-efc127f99c90 at: 05/20/2024 18:52:18
Suggestion To thank Quote Answer

5/20/2024 6:56 PM	Rate (0)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 11/6/2024 Posts: 34151 Rating: (4254)	I already wrote: You cannot switch a digital input (Ix) on and off by using the CMR. You can only query the status of a digital input (Ix) by using the CMR.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on