Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

After powering 6ES7193-6BP00-0DA0 i have no 24V DC in "White pin" section

Created by: PaulM1997 at: 7/31/2024 1:47 PM (2 Replies)

Rating (0)

Thanks 4

3 Entries

7/31/2024 1:47 PM	Rate (0)
PaulM1997 Joined: 4/2/2024 Last visit: 8/30/2024 Posts: 2 Rating: (0)	Hi, in ET200SP i use a 6ES7193-6BP00-0DA0 as a base and 6ES7136-6BA01-0CA0 mounted in shown in Fig1. After i give power to 6ES7193-6BP00-0DA0 last section red and blue pin (Fig2), the white section didn't give 24V DC output (Fig3) . Is there something more to do ? Attachment Topic_Pictures.pdf (484 Downloads)

Suggestion To thank Quote Answer

8/1/2024 5:58 PM	Rate (0)
CaOd Platinum Expert Joined: 5/6/2010 Last visit: 11/5/2024 Posts: 1988 Rating: (279)	Hello, so far I can see, all power-LED at your modules are on. Maybe you make a mistake during your measuring. Please measure directly at the module (both cable from the instrument connect to the base unit). It's possible that you have a challenge with different grounds at your system. regards CaOd

Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users sancruz PaulM1997

8/5/2024 8:15 AM	Rate (0)
PaulM1997 Joined: 4/2/2024 Last visit: 8/30/2024 Posts: 2 Rating: (0)	I found the solution. My Coworkers saied that they configured the safety modul right but they put Channels 0-7 as External Supply

Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users S_Moderator CaOd

|

Share this page:

Share this page on...

Follow us on