Navigation

Replacement of CB2 Card

Created by: aamirawan91 at: 10/10/2024 6:22 PM (1 Replies)

10/10/2024 6:22 PM	Rate (0)
aamirawan91 Regular Member Joined: 3/6/2022 Last visit: 10/23/2024 Posts: 107 Rating: (2)	We our encountering F082 fault on our drive (6SE7018-0TA21-Z). This drive to connected to a B&R PLC via CAN protocol using CB2 (6SE7090-0XX84-0AE0). We now need to replace the CB2 card. I am wondering if it would be just 'plug & play' or do I need to do any parameterization after the replacemnt of this card? Such as the Bus address or something? I believe the Bus address is in the CU2 card but just making sure. Just in case I need to change the bus address do I need to change the parameter P060 (P053) in my case to be able to change the bus address 918?

Suggestion To thank Quote Answer

10/11/2024 12:45 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 11/14/2024 Posts: 5941 Rating: (816)	Hello, I think you mean CBC board. This board doesn't have own parameters or possibilities for setting address etc. as this are all parameters at the CU2. So it should be possible to replace it just taking the switches for bus terminating into account. Attachment op_cbc_d_e.pdf (64 Downloads)
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users aamirawan91