Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

CP342-5

Created by: Coach at: 9/19/2006 11:50 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

9/19/2006 11:50 AM	Rate (0)
Coach Posts: 7 Rating: (0)	Hello, I've got a CP342-5 which must communicate with 2 ET200M with IM153-1 in each. My CP342-5 is a master DP. When i use the DP_RECV bloc in th OB1, I've got the status 8090 which means an incorrect address but my address is good. No DP_Send is used because I only have AI card in the ET200M. Help please Attachment SIEMENS_ALARMES V2.1.zip (822 Downloads)
Coach Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

9/19/2006 12:05 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/15/2024 Posts: 8768 Rating: (1171)	Hello Coach, You have put in a wrong adress for the CP342-5. You'll have to use the Hex-adress off the card. Now you have used the decimal adress as a Hex value. Use w#16#160 in stead off w#16#352 Hope this will help. Best regards, Wizard

Suggestion To thank Quote Answer

9/19/2006 12:54 PM	Rate (0)
Coach Posts: 7 Rating: (0)	Oh yes! I'm stupid! Thanks a lot.[:blush:]
Coach Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

9/20/2006 6:10 PM	Rate (0)
Late Platinum Expert Joined: 1/7/2006 Last visit: 11/17/2023 Posts: 2705 Rating: (318)	Hello Coach, Your not stupid. but learning all the time... [;)]
	I hope that the answer will help, if you have still questions, don't hesitate to ask me. All the best, Late Never say never, think in solutions, not in trouble......
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on