error try to commission axis in manual mode

 hi 

i am using the same cpu as you (1212c-AC/DC/RLY ) but i am trying to use the internal pulse generator PTO1 which is assigned internally to outputs Q0.0 and Q0,1

i try to commission this axis in manual mode and keep getting this error message,

 Parameter settings of pulse generator (PTO) are invalid. (Address is invalid).

any clues where to check ?

Przemos169

Hello all,
thanks for yours hints, now all work very well. I had probably mistake in device configuration. Everything started to work when I unchecked "Enable the use of system memory byte". Maybe I used some tag where I should not.

Stupid mistake but thanks all.

------------------------------------------------------------------------------------------
Split from Motion_Control_Axis_Adress_S7-1200.

closed cause question published twice.

The second thread with the subject axis parameter setting for pulse generator invalid (address invalid) is published within the same conference.

Best regards
CS Moderator