Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Simulation PXC50/100/200 in combination with Desigo CC v3.0

Created by: fons van der meer at: 2/2/2018 1:34 PM (4 Replies)

Rating (3)

Thanks 1

5 Entries

2/2/2018 1:34 PM	Rate (1)
fons van der meer Experienced Member Joined: 1/2/2012 Last visit: 11/13/2024 Posts: 27 Rating: (7)	Hello, I am looking for a way to simulate a PXC50/100/200-E.D in combination with Desigo CC v3.0 so that I can simulate and test my CFC programma with XWorks and my Desigo CC graphics at the same time. This was already posible with Desigo Insight but is this feature also available in Desiog CC v3.0. There is a demo project for Desigo CC where you can simulatate graphics but I can not get it to work for my own project. Does anybody know if this is posible and have some documentation for this setup. Best regard, Fons
	Last edited by: fons van der meer at: 2/2/2018 1:34:51 PM
Suggestion To thank Quote Answer

2/5/2018 5:22 PM	Rate (0)
Vasia Pupkin Advanced Member Joined: 1/6/2017 Last visit: 12/24/2020 Posts: 55 Rating: (1)	Hello. The program has a test mode, where you can check the graphics without controllers.
	Last edited by: Vasia Pupkin at: 2/5/2018 5:23:03 PM Last edited by: Vasia Pupkin at: 2/5/2018 5:25:31 PM
Suggestion To thank Quote Answer

2/8/2018 3:11 PM	Rate (0)
fons van der meer Experienced Member Joined: 1/2/2012 Last visit: 11/13/2024 Posts: 27 Rating: (7)	I know that there is a simulator onboard in Desigo CC but I would like the same functionality that Desigo Insight had with the simulator in combination with XWorks. I have asked the support team in the Netherland to take a look at this. Hope to here from them soon.

Suggestion To thank Quote Answer

2/12/2018 4:52 PM	Rate (2)
Albis Silver Expert Joined: 6/4/2010 Last visit: 9/30/2024 Posts: 387 Rating: (130)	Dear Fons, The Desigo XWP controller simulation works together with Desigo CC as well. Please find attached to this post a short guideline about how to do the settings required. The controller simulation can be used for the verification of your Desigo CC graphic engineering with online values from the simulated controller. The Automation Station simulation also helps to increase the engineering efficiency and quality of the PX application. Please note that there is a Desigo CC demo which has its own simulation of the subsystem. Best regards, Albis Attachment XWPControllerSimulation_DesigoCC_Connection_en.pdf (1187 Downloads)

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users PontaDoMel

2/15/2018 1:13 PM	Rate (0)
fons van der meer Experienced Member Joined: 1/2/2012 Last visit: 11/13/2024 Posts: 27 Rating: (7)	Dear Albis, Thanks al lot for your anwser. I got it to work. This is helping me a lot to test my work properly. Best regards, Fons

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on