Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Setpoints in logo display with 1 decimal

Created by: SnickeSnack at: 9/14/2020 11:42 AM (3 Replies)

Rating (0)

Thanks 1

4 Entries

9/14/2020 11:42 AM	Rate (0)
SnickeSnack Member Joined: 4/17/2020 Last visit: 4/13/2021 Posts: 2 Rating: (0)	Hey, Using Logo! Soft Comfort and an BM 24RCE to control a pump in a well witth water. I have an analog signal with the level in the well that I scaled to 0.0-10.0meter. My problem is that I want to use set points from the display that use 1 decimal. Now I have it so I can set the start/stop-levels in centimeters and it works, but I want the setpoint in meters with 1 decimal. Is it even possible to input float in the Logo and then convert it to an integer for a analog threshold? Br,

Suggestion To thank Quote Answer

9/14/2020 11:47 AM	Rate (0)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 11/7/2024 Posts: 34150 Rating: (4254)	Hello SnickeSnack, at first welcome to the forum. The LOGO! knows only integers, no float. In order to be able to enter a nominal value with one decimal place, you can, for example, use a mathematical instruction and enter a decimal place under the properties of the block. How is the measurement parameterized?

Suggestion To thank Quote Answer

9/14/2020 11:52 AM	Rate (0)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 11/7/2024 Posts: 34150 Rating: (4254)	In attachment an example... Attachment Untitled.png (238 Downloads)

Suggestion To thank Quote Answer

9/14/2020 12:22 PM	Rate (0)
SnickeSnack Member Joined: 4/17/2020 Last visit: 4/13/2021 Posts: 2 Rating: (0)	Thank you so much! It works like a charm!

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ixo65

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on