Need to reload 810t with plc files and data etc

Pee Ell Sea

Hi,

Sounds like you need to start by going into eyeball mode (startup) and clearing the system down by formatting the memories. Loading the standard machine data and formating the nc memory again. Then reload all of your data and reformat the nc memory once more.

Then load the plc and you should be up and running.

You will also need a copy of the plc generated error message texts whcih have to be loaded in startup mode.

 Hi, I need to reload my 810t with my plc files and data etc.  I have all of my files but must not have the correct procedure to reload. Can you give more detail for the reload procedure and or do you have a document to outline the procedure?  I have tried the generic Siemens uploading procedure but can’t seem to get it to work and you have described a different loading process than what I have tried.  Any and all help would be appreciated, thank you.

------------------------------------------------------------------------------------------
Split from NC Alarm 2000 Cannot Reset!!?.

New question published by AutoGen_312710 is split to a separate thread with the subject Can not create back up of Sinumerik M GA3 (milling machine.

Best regards
The Helping Hand