SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

S7-1200 TIA13 SP2 Motion control problem

4/22/2018 4:48 AM	Rate (0)
wodji Posts: 3 Rating: (0)	Hi I tried to setup motion control for stepper motor PTO and I can't assign outputs for Pulse and Direction signals. I tried couple of different CPUs but the same situation. Please help. Regards wodji Attachment Snap1.jpg (249 Downloads)
wodji Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

4/22/2018 9:22 AM	Rate (0)
#dP Posts: 2826 Rating: (692)	wodji Hi I tried to setup motion control for stepper motor PTO and I can't assign outputs for Pulse and Direction signals. I tried couple of different CPUs but the same situation. Please help. Regards wodji Hello. See the attached picture for a recommendation to reconstruct the motion control. BR Attachment reconfigure motion control.png (257 Downloads)
#dP Posts: 2826 Rating: (692)
Suggestion To thank Quote Answer

4/22/2018 1:09 PM	Rate (0)
wodji Posts: 3 Rating: (0)	Thank you but it didn't help. I did all suggestions and this is what I got in step 4. Attachment Snap2.jpg (222 Downloads)
wodji Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

4/22/2018 2:41 PM	Rate (0)
wodji Posts: 3 Rating: (0)	Founded I have been using relay output, i just add 5vdc 4 output signal board.
wodji Posts: 3 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users #dP

Share this page:

Share this page on...