Hi, recently I upload a program from an 315-2 DP (6ES7315-2AF02-0AB0) but when I check consistency it shows some errors from simovert and micromaster drives configuration. What can I do to solve the error. I attached images from the hardware configuration and the errors.

I´m using step 7 v5.5. I need this cause I want to replace the CPU with a new one (6ES7315-2AH14-0AB0)

Thanks in advanced.

I think I will follow this topic

https://support.industry.siemens.com/tf/mx/es/posts/s7300-program-help/71263/?page=0&pageSize=10

Hi syd,

did you try it? Does it solve your problem?

Best regards,

Noodles

Until yesterday I could test it, and it worked.

In HW Config I errased all drives from the profibus network, before this you should check the I/O Addresses. If you don´t know the addresses you could view them by clicking View>Address Overview… It shows the address and the length of PKW and PZD. 

I just add the Masterdrive CBP , from the catalog, to the nertwork and configured the I/O Addresses.

Used Step 7 5.5, also installed in PC DriveES SIMATIC 5.4 

Hope this helps.