Hello, How do you download parameter from a Micromaster Vector drive? and does anyone know how to adjust any parameters to stop f001 fault?

cflex_tech49

Hello, How do you download parameter from a Micromaster Vector drive? and does anyone know how to adjust any parameters to stop f001 fault?

Parameters 'could' be accessed by the RS485 port on the drive front.

A 'clear text operator panel OPM2', was available 6SE3290-0XX87-8BF0 with a PC cable 6SE3290-0XX87-8SK0, and a 5Volt power supply, which made connection possible for USS Software (RS232 to RS485), software which I cannot now locate, lost to history.

The drive is not too complex, with far fewer parameter settings as are available for new Siemens drive devices; manually copying down all the parameters would be quicker that locating the necessary parts, hard and software.

The drive is tripping with Over Voltage F001, indicating a high supply Voltage, or the motor is being 'pushed' into generating mode, or the drive is 'jiggered'. Being some 25 years old now, this may be the case to consider.

Information is available, manuals etc, on internet using the Siemens part numbers, which may help.

Come back if I can help further

Tractor

Tractor

 

cflex_tech49

Hello, How do you download parameter from a Micromaster Vector drive? and does anyone know how to adjust any parameters to stop f001 fault?

 

Parameters 'could' be accessed by the RS485 port on the drive front.

A 'clear text operator panel OPM2', was available 6SE3290-0XX87-8BF0 with a PC cable 6SE3290-0XX87-8SK0, and a 5Volt power supply, which made connection possible for USS Software (RS232 to RS485), software which I cannot now locate, lost to history.

The drive is not too complex, with far fewer parameter settings as are available for new Siemens drive devices; manually copying down all the parameters would be quicker that locating the necessary parts, hard and software.

The drive is tripping with Over Voltage F001, indicating a high supply Voltage, or the motor is being 'pushed' into generating mode, or the drive is 'jiggered'. Being some 25 years old now, this may be the case to consider.

Information is available, manuals etc, on internet using the Siemens part numbers, which may help.

Come back if I can help further

Tractor

 We have Drive monitor software   version 5.4.0.1  would this be able to communicate and pull out parameters?

Thank you