ovione1

Hi guys, i'm new on programing V20, till now i successfully wire a motor (3kW) with Cn006 - External push button control, it's working fine (the controls are remote start /stop). 

now i have 2 more problem to solve:

1- i need a feedback that v20 it's start running when i press start button (running lamp)

2- it's possible to add some delay when i press stop button? (motor need to run like 20 min before stops when i press stop button) 

Digital outputs: 

P0731:0 = 52.3, 52.2 inverter running.

Note:

r0052:0 ...15, this is the 'status word' of the V20

Configuration for a 20 Minute delay of stopping after the run command is removed

P0701= 99, free din0..edit

P2800 = 1, enable free function blocks

P2801:3 = 1, activate function blocks, enable OR block

P2801:0 = 0, enable OR block

P2802:0 = 1, enable timer 1.

P2849 = 722:0, connect timer input to DIN0, edit.

P2850 = 20, time delay

P2851 = 11, off delay minutes

P2816:0 = 2852, connect 1 to OR1.

840:0 = 2817, run command.

In brief, OR1 has an input from Timer T1 and the run switch direct, on loss of the run switch the T1 timer maintains the run command until the time expires.

I have made this list from the manual, as I do not have a serviceable V20 for testing, I believe it should work.

Tomorrow now, I will, try to draw this up so you could make some sense of the configuration.

Tractor

Hi

See some amendments to the previous solution, where I have gone wrong.

I have now attached a drawing ppt. for clarity.

Tractor

AutoGen_7147393

Sorry if not mistaken Digital Output 52.3 is for fault indication, for running indication is 52.2

 You are correct this should read 52.2, 'Operation Enabled'.

Think I made a bit of a mess of this one, thanks for the input, all should be right now??

Tractor