Hi everyone,

I'm a student in electrical engineering and I have as project to configure an IOT2050 advanced FS-05.

I followed the instructions to configure it with the OS stick but when I try to make a connection using an UART cable nothing happen on PuTTy, I think it's because I tried at first to boot it with an wrong image ( I put into it an SD card with the image V1.1.1 but I realised it was for IOT2050 not for 2050 Advanced ) and now I can't boot on the OS stick.

What can I do now to get acces again and boot normally with the OS stick ?

Thanks !  

Hi, 

You still have the wrong image into the micro SD card? U should install the correct image from the following link: Downloads for SIMATIC IOT20x0 - ID: 109741799 - Industry Support Siemens

To erase the wrong image from your SD u can use disk administrator of windows, or SD card formatter:

SD Memory Card Formatter for Windows/Mac | SD Association (sdcard.org)

After that follow this instructions to install the SO: Application description (gothightech.com)

You should be able to connect via Putty with the ethernet interface of IoT. Default ip is 192.168.200.1 (interface 1) and port 22. 

Best regards,

Javertz.

Hi Javertz ! 

I tried to install the 1.3.1 image as you said but nothing change i can't make a connection using the IP on Putty neither with the UART cable.

Hi bergmanu !

The stat led stay green and when I try to open the UART connection there is no output on PuTTy even if I open it before powering the IoT.