SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

how can set the parameters?

3/26/2024 1:23 PM	Rate (0)
AV1234 Member Joined: 9/12/2020 Last visit: 3/28/2024 Posts: 22 Rating: (0)	Hello, I have a simular question. I have 1 start pulse an 1 stop pulse how can I set the parameters for this. ------------------------------------------------------------------------------------------ Split from G120 PM240-2,CU240B-2 3 wire control .
	Last edited by: Jen_Moderator at: 03/27/2024 08:49:18 New subject after splitting
Suggestion To thank Quote Answer

3/28/2024 8:37 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 11/12/2024 Posts: 5938 Rating: (816)	Dear AV1234, basically it is not realized in the standard configuration to start and stop a G120 only with a impulse and two DI's. Please check chapter 8.5 of the instruction maual of the G120. There are some makros shown how to control a drive with only 2 or 3 signals. To get your requested functionalitiy please use the free function blocks of the G120. For example you can use a RS-flipflop and connect it with the ON/OFF signal (p840) of the G120. As setpoint you can use the fixed setpoint in p1001 for example.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users 0_Einstein

3/28/2024 4:21 PM	Rate (0)
Tractor Gold Expert Joined: 3/27/2008 Last visit: 11/12/2024 Posts: 1147 Rating: (142)	Hi I prepared this some time ago, it provides 'Momentary Contact Start, and also a switch between Command Data Sets 0 and 1. I have indicated the bits required for momentary contact start. Have a look and come back if I can help further. Tractor Attachment Momentary contact start.pptx (520 Downloads)
	Tractor
Suggestion To thank Quote Answer

Share this page:

Share this page on...