SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Fuel Level Sensor - programming

12/27/2010 10:40 PM	Rate (0)
hamzasiemens Posts: 19 Rating: (0)	Hi ! Can you please share the programming of Fuel level sensor using LOGO please...
hamzasiemens Posts: 19 Rating: (0)	Last edited by: CS Moderator at: 12/28/2010 10:41 AM new subject after splitting
Suggestion To thank Quote Answer

12/27/2010 11:19 PM	Rate (0)
Toeternietoe Platinum Member Joined: 12/27/2006 Last visit: 8/18/2024 Posts: 1197 Rating: (113)	Ist a easy programm. I have made it for a sensor 0 - 4 Meter Water Attachment Vegawell.zip (408 Downloads)

Suggestion To thank Quote Answer

12/28/2010 9:46 AM	Rate (0)
hamzasiemens Posts: 19 Rating: (0)	Hi ! Thanks for providing the program but can you please explain how it work?
hamzasiemens Posts: 19 Rating: (0)
Suggestion To thank Quote Answer

12/28/2010 6:59 PM	Rate (0)
Toeternietoe Platinum Member Joined: 12/27/2006 Last visit: 8/18/2024 Posts: 1197 Rating: (113)	Is your sensoroutput 0-10 Volt or 4-20mA? A sensor 0-10V can be connected directly to a LOGO! DC. A sensor 4-20 mA must connected to a LOGO!: with a resistor 500 Ohm to a analog input of the LOGO, so you make from 4-20 mA a 2-10 Volt signal, Or Use a Analog expansion module p.e. AM2 Working with analog signals: Most of time yuo use a Analog Amplifier as Firs block , connect it to te Analog input. In this analog Amplifier you can make the input signal 4-20 mA etc to a 0- 1000 signal intern in the LOGO!. Thats make it easy to make a good signal for futher use in the LOGO! After te Analog Amplifier you put a Analog switch. Its go on by ..... and of by ........ (..... yuo have to put the right valuwe) Because it works wrong, you must invert the output, and connect it to a LOGO! output. I have use a Text-block So you can see how it works. Sorry im a Dutch, my Englisch is not so verry good, ill hope you understanding my expanations.

Suggestion To thank Quote Answer

Share this page:

Share this page on...