Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

commnucation error CP441 and CP525

Created by: vaz martins at: 9/17/2007 6:49 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

9/17/2007 6:49 PM	Rate (0)
vaz martins Posts: 2 Rating: (0)	Hello everyone I'm trying to connect an S7-400 CP441 with protocoll RK512 with a S5 CP 525. In netpro i configure a connection between the CP and a device S5. From the CP525 i'm using the send-all, receive-all mechanism and i configure the CP525 with RK512 and 3964R protocoll I'm trying to use the "get" and "put" function. In both situations i have the same error that means i cannot address the partner. For example when using the GET" function I use "P#DB34.DBX30.0 word 2" for ADDR parameter. The DB exists on the S5 side.Yet i receive an error number 8H (addressing error at partner). My question is: what is the syntasse to address da DB34.DW 30 to receive 3 words?
vaz martins Posts: 2 Rating: (0)
Suggestion To thank

9/18/2007 9:37 AM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/18/2024 Posts: 8770 Rating: (1171)	Hello, In my opinion, you cann't use the Put and Get functions Please have a look at following link, use B-send: http://support.automation.siemens.com/WW/view/en/24414928 and http://support.automation.siemens.com/WW/view/en/24575242 Hope this will help. Best regards, Wizard

Suggestion To thank

9/18/2007 10:16 AM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 11/18/2024 Posts: 4113 Rating: (195)	closed cause question is discussed within another thread too: Thisthread with the subject error using GET function between S7 and S5is published within the conference Communication / Networks. Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on