SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Analog output card - voltage output question

1/22/2008 3:44 AM	Rate (0)
Daniel1983 Posts: 25 Rating: (0)	Hi! I want to use the 6ES7332-5HD01-0AB0 analog output card to create a voltage output, but in the S7-300 Module Data document only the wiring instructions for current output are shown... They show two types of wiring: 1) 2 and 4-wire measuring transducer for current measurement 2) Current output Do I need to use the first wiring type for a voltage output?
Daniel1983 Posts: 25 Rating: (0)
Suggestion To thank Quote Answer

1/22/2008 4:53 AM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 11/11/2024 Posts: 12293 Rating: (2691)	Hello Daniel1983; What manual are looking at? There is a S7-300 Module Data manual that has a full chapter on S7-300 analog modules, including your particular 332-5HD01. It also shows different connections of output loads, 4-wire or 2-wire. I have extracted some of the data in the attached file, please download and study the manual for more details. Hope this helps, Daniel Chartier Attachment SM332_Voltage.jpg (542 Downloads)

Suggestion To thank Quote Answer

1/22/2008 7:06 AM	Rate (0)
Daniel1983 Posts: 25 Rating: (0)	Thanks Daniel! So, for, example, with channel 0 I need to connnect together pin 3&4 and pins 5&6. I understand now - thanks!
Daniel1983 Posts: 25 Rating: (0)
Suggestion To thank Quote Answer

2/24/2008 2:21 PM	Rate (0)
AnproScott Advanced Member Joined: 5/31/2007 Last visit: 9/18/2024 Posts: 90 Rating: (2)	Hi, everyone: I read the page 355 of the manual. ButIusedthis AO module that way and it workedbefore : With channel 0 Ionly used pin 3 and pin 6output to the load, With channel 1 Ionly used pin 7 and pin 10 output to the load. Is there anybody wiringlike this way I mentioned?? Daniel1983 Thanks Daniel! So, for, example, with channel 0 I need to connnect together pin 3&4 and pins 5&6. I understand now - thanks!
	Last edited by: SexDriver at: 24.02.2008 14:23
Suggestion To thank Quote Answer

10/15/2008 7:40 PM	Rate (0)
Vijay_Khatri Posts: 23 Rating: (2)	Dear Daniel, You can change the measuring range for AO module in HW Confugration. Go to properties of module you added in HW Config, and then slect the out put tab from the tab menu. Here you get the option to change the option for either voltage or current type output. Hope that works.
Vijay_Khatri Posts: 23 Rating: (2)
Suggestion To thank Quote Answer

Share this page:

Share this page on...