SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

IM151-7 CPU

5/4/2006 8:08 PM	Rate (0)
dream1 Posts: 13 Rating: (0)	HELLO, I need insert a IM151-7 CPU in my DP master system, but I can't, the step 7 tell me, only I can insert IM151-7 CPU into a rack nº 0, if possible I need information to resolv this. My best regards...
dream1 Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

5/5/2006 8:39 AM	Rate (0)
Chris Silver Member Joined: 8/31/2005 Last visit: 10/24/2024 Posts: 217 Rating: (41)	Hi! Because the IM151-7 CPU contains a S7-Program you have to add an own SIMATIC 300 station into your STEP 7 project (via the SIMATIC Manager). Open the HW Config for this new station and insert the IM151-7 CPU (drag-and-drop the IM151-7 CPU to the HW Config) Open the Properties dialog of the MPI/DP interface of the IM151-7 CPU. Connect the MPI/DP interface to a PROFIBUS network (via the "General" tab) Add a new Master-slave configuration via the "Configuration" tab. Here you set the input and output addresses of the IM151-7 CPU slave (These are the addresses that can be accessed from the local IM151-7 CPU S7 program). Save and Compile your HW Config. Open the HW Config of the Station, that contains the DP master of the IM151-7 CPU Add a "ET200S / CPU" slave (in Catalog: PROFIBUS DP -> Configured Stations -> ET200S / CPU") to the DP master system. In the DP slave properties window (in the "Connection" tab) you setup the connection you IM151-7 CPU (By pressing the "Connect" button). In the "Configuration" tab of the same properties window you have to set the local addresses for the DP master (These addresses are accessed in the DP master S7 program). Hope that helps...
	Greetings, Chris
Suggestion To thank Quote Answer

5/5/2006 8:50 AM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/11/2024 Posts: 8768 Rating: (1170)	Hi, In the following link, you can download the manual: http://support.automation.siemens.com/WW/view/en/12714722 And the chapter 2.8 describes how to connect a IM151-7 CPU to a DP-master. Hope this will help. Best regards, Wizard

Suggestion To thank Quote Answer

5/5/2006 10:21 AM	Rate (0)
Morten Bronze Member Joined: 9/27/2005 Last visit: 4/26/2024 Posts: 203 Rating: (32)	Additionally a small remark: IM157-7 CPU is also stand alone possible.

Suggestion To thank Quote Answer

Share this page:

Share this page on...