Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

UPS1600 no communication with the battery modules.

Created by: @AutoGen_817086 at: 1/19/2024 2:28 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

1/19/2024 2:28 AM	Rate (0)
@AutoGen_817086 Joined: 1/19/2024 Last visit: 1/29/2024 Posts: 3 Rating: (0)	I have issue, I have re-installed on a configured UPS1600 system six new UPS1100 modules however what I am normally used to the communication automatically being established and LEDs on the UPS1100 going green. However this time the UPS1100 module LED did not light and 24 hours later I still have no communication with the battery modules. I have checked the both the power and signal wiring and they are correct. Is this an issue of the UPS1600 not establishing communication or the individual UPS1100 battery modules. The UPS1600 is working just no communication with the battery modules. Regards, Marc ------------------------------------------------------------------------------------------ Split from SITOP UPS1600 with UPS1100 problem.
	Last edited by: U_90bbd655-34cb-4a69-9b6e-3136983d42b0 at: 01/19/2024 02:29:01 Last edited by: Jen_Moderator at: 01/19/2024 10:31:58 New subject after splitting
Suggestion To thank Quote Answer

1/22/2024 5:23 AM	Rate (0)
vahid4pc Member Joined: 10/9/2021 Last visit: 10/26/2024 Posts: 39 Rating: (6)	Hi Did you configure the hardware and choose the amount of modules in the hardware configuration? Best regards
	Your feedback is much appreciated, please rate.
Suggestion To thank Quote Answer

1/23/2024 2:07 AM	Rate (0)
@AutoGen_817086 Joined: 1/19/2024 Last visit: 1/29/2024 Posts: 3 Rating: (0)	The communication was working fine with the original 6 modules before the re-install of the new 6 modules. Nothing was changed in the settings, so I thought it would be a simple case of plug and play.
	Last edited by: @AutoGen_817086 at: 01/23/2024 02:08:42
Suggestion To thank Quote Answer

1/25/2024 1:24 PM	Rate (0)
AutoGen_463075 Regular Member Joined: 4/28/2015 Last visit: 10/18/2024 Posts: 30 Rating: (1)	Hello, did you reboot the UPS1600 after changing the batteries? Greeting.

Suggestion To thank Quote Answer

1/26/2024 3:56 AM	Rate (0)
@AutoGen_817086 Joined: 1/19/2024 Last visit: 1/29/2024 Posts: 3 Rating: (0)	I turned off the power to the UPs and then waited 10 seconds and powered it back up, still no comms to the 6 modules. Regards, Marc

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on