SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

IPC427D (Microbox PC) - problem with downloading Hardware to PLC from Simatic Manager

11/3/2023 8:38 AM	Rate (0)
ziemniaq Posts: 7 Rating: (0)	Hi. I am repeating the question in another category, and I originally presented the topic in the link below, unfortunately without an answer... https://support.industry.siemens.com/forum/pl/en/posts/ipc427d-microbox-pc-put-the-mode-selector-into-the-run-p-or-stop-position/288880 When trying to upload Hardware in NetPro after the modifications, the following message appears: "This action cannot be executed because the mode selector on the module is in the RUN position. Put the mode selector into the RUN-P or STOP position." Putting this driver in STOP mode using a software switch (hotkey CTRL + I) does not help, so it must be a physical switch in Microbox PC (so called keyswitch). The problem is that I can't find it anywhere or find it in the PDF documentation for this module (6AG44140-1BK04-3AB0). I am asking the honorable forum team for help. Attachment 20221001_081133.jpg (681 Downloads)
ziemniaq Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

11/3/2023 12:16 PM	Rate (1)
JBS98 Experienced Member Joined: 7/19/2022 Last visit: 12/23/2025 Posts: 436 Rating: (72)	Hello ziemniaq, If you are using WinAC RTX on the Microbox you must stop the PLC from the WinAC control: SIMATIC Windows Automation Center RTX WinAC RTX (F) 2010
	If this Information really helps, you could use the Rate function Best Regards, JBS98
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ziemniaq

11/13/2023 6:19 AM	Rate (0)
ziemniaq Posts: 7 Rating: (0)	Actually, I didn't think about it - I don't work enough with these toys :) I connected an additional monitor with a mouse and keyboard to the Microbox PC, and it was all downhill from there. Switching to STOP in the WinLC RTX application and loading the Hardware to the controller was successful. However, when I tried to do it from the NetPro level - it was still asking to switch the controller to STOP even though it was already in this state. However, after compiling the network changes in NetPro and loading the configuration to the PLC from the HW Config level, everything works and communicates both via Ethernet and Profibus. Thank you for your help. Attachment microbox_stop_mode.jpg (720 Downloads)
ziemniaq Posts: 7 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users Jen_Moderator JBS98

Share this page:

Share this page on...