Hello Cerberus13,

here is the link to a manual programming safety where this is explained.
There you can find the configuration at chapter 2.

Please check at your project if the firmware is the same like at your module.
Otherwise update the firmware at your modul.

There are any informations at your diagnostic of the modul?

regards
CaOd

How can I do that? (check the firmware version).

In the project I can see it in "Properties" but what about module?

I download firmware update for the module

Firmware Update for ET 200SP F-DQ 4x 24V/2A DC

but I can't open page with "Description" - it's open empty page by the link....

How can I make update for the module? (TIA Portal 14 SP1)

Hello Cerberus13,

yes the link  to the description is down.
I give Siemens a information about this problem.

Firmwareupdate

• open device view
  
• select the device
• select the module
• open the diagnosis (Ctrl + D)
• connect the module (go online)
• select of the left site Firmware update
  
• select the necessary file
• udate your module

In my opinion you was not online connected with the module.

Hope this helps.

regards
CaOd

Actually I found how to see module's firmware version. My module has v1.0.3 (that's actual version this moment).

I have no idea what happened with this module....

Hello Cerberus13,

how looks your configuration of each channel?

I can't describe it but I think you have a problem at your configuration at the channels.

Can you send some screenshots of your configuration?

regards
CaOd

Hello Cerberus13,

your parameters are ok (it's standard).
This error is a little bit difficult and crazy.

Can you tell me which LED is lighting at the modul?

Second suggestion:
remove this card from your device in the program, compile it.
Add the modul again and compile it again.

It's not a logical suggest but...

regards
CaOd

Hello CaOd,

DIAG is blinking with green colour