Topology Error: CU320 GSD?

ChristophD

Hello,

you are correct, the ALM and SMM are to old for the CU320-2 with FW V4.x.

You need Ordernumber ending on 3 or above.

Regards

Christoph

Good afternoon,
I am in the same situation as the colleague who made the inquiry above. I have:

• ALM (Active Line Module): 6SL3130-7TE23-6AA1
• SMM (Single Motor Module): 6SL3120-1TE21-8AA1
• CU320-2PN: 6SL3040-1MA01-0AA0

And when I link them with Starter, it shows a topology error. I understand that it might be due to equipment incompatibility. Is there any way to achieve this link?
Because I also have the CU320: 6SL3040-0MA00-0AA1, but for my project, I need to communicate all this with an S7-1500R system, which is programmed in TIA Portal v17, and I do not have the GSD file for the CU320. Is there any place where I can find this GSD file?

Thank you very much, regards.

------------------------------------------------------------------------------------------
Split from CU320-2PN - Actual topology not permissible in STARTER.