Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

RF310R 0xE7FE01

Created by: Luchian at: 6/21/2017 9:24 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/21/2017 9:24 AM	Rate (0)
Luchian Experienced Member Joined: 8/21/2016 Last visit: 7/12/2022 Posts: 20 Rating: (0)	Hi guys, I have some RF310R readers. When I try to read or to write something E7FE01 error appears. (In this status, only the "Reset_Reader" command ("WRITE-CONFIG") is permitted.) I don't understand this problem.. What can I do ? EDIT: Also, the presence bit is always 0. Attachment rfid.JPG (287 Downloads)
	Last edited by: Luchian at: 6/21/2017 10:21:25 AM
Suggestion To thank Quote Answer

6/21/2017 10:56 AM	Rate (0)
Owei Gold Expert Joined: 10/1/2013 Last visit: 5/8/2024 Posts: 605 Rating: (71)	Hi Luchian, before reading or writing with your reader you need to reset it. Therefore there are "Reset_xxx" blocks in the TIA instruction library. After powering up the reader it's LED should flash green (waiting for a reset). After a successful reset the LED steadily shines green (run mode). After resetting the presence bit will show.
	Last edited by: Owei at: 6/21/2017 10:57:35 AM Last edited by: Owei at: 6/21/2017 10:58:07 AM
Suggestion To thank Quote Answer

6/30/2017 1:19 PM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (172)	New question published by Thimberg is split to a separate thread with the subject Problem with RF310R and Transponder R320T. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on