CU320-2DP Analog output

Dear Experts,

I would like to use analog output of CU320-2DP in order to send motor current data to other PLC for data logging.

How can I do it please help me !!!

Best Regards,

Vorapob

TechTeam

Dear Vorapob,

the CU320-2DP don`t come with onboard analogue outputs.
You have to use additional terminal boards or terminal modules, see equipment manual.
https://support.industry.siemens.com/cs/de/de/view/109754294/en

If you have an analog output you can interconnect the wanted current parameter to the analog output parameter.

 Dear TechTeam,

How can I configuration this analog output and motor parameter ?

Best Regards,

Vorapob

Hello,

CU320-2DP do not have on board AO, so user need to select either TB30 (plug in) or TM31 (Drive CLiQ interface) modules.

If TB 30 is selected user can derive -/+ 11V at terminal X482.5 & X 482.6.

If TM 31 is selected user can derive either +/- 10 Volt AO output at terminals X521.1 & X522.2 or +/- 20 mA at X522.3 & X522.2. Use need to connect r0068 (smoothed absolute current value) to p4071, to select analog out put type set p4076 as per requirement.

HTH

PISCEAN 2010

Hello,

CU320-2DP do not have on board AO, so user need to select either TB30 (plug in) or TM31 (Drive CLiQ interface) modules.

If TB 30 is selected user can derive -/+ 11V at terminal X482.5 & X 482.6.

If TM 31 is selected user can derive either +/- 10 Volt AO output at terminals X521.1 & X522.2 or +/- 20 mA at X522.3 & X522.2. Use need to connect r0068 (smoothed absolute current value) to p4071, to select analog out put type set p4076 as per requirement.

HTH

 Dear PISCEAN 2010,

For this 2 way.

Is it have to edit the CU320 configuration ?

Is it will effect to the old CU program ?

Best Regards,

Vorapob