Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

SINUMERIK 802D error 025201

Created by: SMiranda at: 1/17/2018 9:07 PM (3 Replies)

Rating (1)

Thanks 1

4 Entries

1/17/2018 9:07 PM	Rate (0)
SMiranda Posts: 1 Rating: (0)	Lilian Good afternoon, I have a punching machine with Siemens 8002D control, it has a problem in the beginning "error 025201" Do you know anyone in the forum that can help me? "Attached image" regards ------------------------------------------------------------------------------------------ Split from SINUMERIK 802D- booting failure. Attachment ERROR 025201.jpg (372 Downloads)
SMiranda Posts: 1 Rating: (0)	Last edited by: Jen_Moderator at: 1/18/2018 11:06:39 AM New subject after splitting
Suggestion To thank Quote Answer

1/18/2018 7:09 AM	Rate (1)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 11/23/2024 Posts: 8092 Rating: (882)	Hello SMiranda, It is not 25201 alarm. Your system has triped on 201315, 201481, 230897, 231897 alarms. These are related with Sinamics drives alarm, signifance is power units missing & communication with CU unit is lost. Please check Drive CLiQ connections, 24 V DC power supply etc etc .

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Milad.P

12/2/2024 12:06 PM	Rate (0)
AutoGen_5553258 Joined: 7/3/2024 Last visit: 12/2/2024 Posts: 1 Rating: (0)	Attachment 20240928_090005.jpg (121 Downloads)

Suggestion To thank Quote Answer

12/2/2024 1:29 PM	Rate (0)
nulizhang Platinum Expert Joined: 10/17/2007 Last visit: 9/3/2025 Posts: 4429 Rating: (398)	What's up AutoGen_5553258
	If you like my comments please use "Thank" bottom left or Rating Top right
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on