Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Simatic Batch V9.0 SP1 Opening Control Center is blocked

Created by: AutoGen_7787853 at: 4/30/2025 10:12 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

4/30/2025 10:12 AM	Rate (0)
AutoGen_7787853 Member Joined: 5/18/2019 Last visit: 9/12/2025 Posts: 1 Rating: (0)	hello, Redundant servers. On the batch client, the control center opening is blocked. Can you help me.

Suggestion To thank Quote Answer

5/20/2025 7:03 AM	Rate (0)
Techno_Taru Bronze-Expert Joined: 1/11/2019 Last visit: 8/14/2025 Posts: 899 Rating: (171)	Ping the Batch Servers On the Batch Client, open Command Prompt and run: ping <PrimaryServerName> ping <SecondaryServerName> Check Control Center Configuration Go to: C:\Siemens\Common\Batch\bin\CCConfig.exe Enter correct names or IPs of the Primary and Secondary servers. Click OK and close. Restart Batch Services on Client Press Win + R, type services.msc, press Enter Restart these services: SIMATIC Batch Control Center SIMATIC Logon Check Redundancy State (on Server) Use Redundancy Status Tool Make sure servers are synchronized and one is active. Reboot the Batch Client After changes, restart the client PC.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on