Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

winder configuration with sinamics s120

Created by: SKG at: 8/25/2011 11:08 AM (11 Replies)

Rating (0)

Thanks 0

Result pages:: |; 1 | 2; |

12 Entries

Entries per page: 10 | all

9/13/2011 3:26 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 9/8/2025 Posts: 6039 Rating: (828)	Hello Shyamal, you need to open the DCC chart, go to page A5 and on the right hand side you find a block called "DiaComp_run" (Diameter computer release). If you select the second input and delete there the connection to "tension_oper1" (only select this pin, not the connection, otherwise you delete al connections from "tension_oper1" output), you diameter computer does not longer require "tension operation".
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

9/14/2011 10:28 AM	Rate (0)
SKG Bronze Member Joined: 5/30/2008 Last visit: 10/22/2024 Posts: 135 Rating: (3)	Hello TechTeam, Thank you so much for giving me the idea. I am going ahead in that direction. Best regards, Shyamal

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on