Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Time Synchronization

Created by: moone at: 3/15/2013 7:46 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

3/15/2013 7:46 AM	Rate (0)
moone Posts: 3 Rating: (0)	Hi, Does any one know the exact function of "MBUS Time Synchronization" under NIM32 tab of APACS+ control panel? Thanks
moone Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

3/15/2013 1:11 PM	Rate (0)
GirlGeek_44 Posts: 3 Rating: (0)	Hi, moone, The MBUS Time Synchronization checkbox in the NIM32 is to allow the IEMs to function as the Time Synch Masterwhen using the newest IEM software. There are Configuration Settings in the IEM's Gateway.ini file which manage configuration and behavior. Section 5 of the current IEM User's Guide describes them in detail. Hope this is helpful! Best, GirlGeek_44
GirlGeek_44 Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

3/22/2013 5:29 PM	Rate (0)
moone Posts: 3 Rating: (0)	GirlGeek_44 Hi, moone, The MBUS Time Synchronization checkbox in the NIM32 is to allow the IEMs to function as the Time Synch Masterwhen using the newest IEM software. There are Configuration Settings in the IEM's Gateway.ini file which manage configuration and behavior. Section 5 of the current IEM User's Guide describes them in detail. Hope this is helpful! Best, GirlGeek_44 Hi GirlGeek, Thanks for your reply. In addition to my previous post, I have no IEM in my network. What I addressed was from a 4-Mation Engineering station connected to 2 resources through Mbus cable. Does it make any sense for my case? Can I synchronize 4-Mation station to resource(getting time from resource not sending time to resource)? Regards
moone Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on