KSN

Look at the attached manual, chapter 5.3. There is a button 'Autodetect processors', try to use it to add new channel.

 Thank you sir. I will try to do it in next shutdown. 

Hi Harry55,

please let us know if your attempt was successful.

@KSN: Thanks for supporting !

schattenparker

Hi Harry55,

please let us know if your attempt was successful.

@KSN: Thanks for supporting !

 I haven't tried yet sir. Whenever mill shutdown, I will try to do it. Is there any caution required please let me know. 

KSN

Look at the attached manual, chapter 5.3. There is a button 'Autodetect processors', try to use it to add new channel.

 Hello Sir, 

                I tried to autodetect processors but in this procuedure old channel got disabled. Only new channel was shown in IBA. After that I restore my old backup. Please suggest any other point which i have to consider. 

KSN

Hello.

Have you read the manual ibaPDA-Request-SD-TDC_v4.4_en.pdf?

Try to configure step-by-step as described in chapter 5. 

 Sir,

      I read all the points and followed all procedure. Equally distributed channels in both FO link but during applying new channel configuration, old channel disabled. Again, backup loaded for data initialization.

Hi,

I suggest to contact your local iba office to get detailed support:

https://www.iba-ag.com/en/contact