Industry Online Support
Technical Forum
Navigation
Rating 
Thanks 0
2 Entries
| 12/1/2010 10:21 PM | |
|
Posts: 2 Rating:
|
hi We tried to interface WinCC Flex SP2 with our Yokogawa STARDOM FCN RTU through MODICON MODBUS TCP/IP Protocol. But unfortunately an error occurred saying “Interface 10.122.210.17 cannot be opened” & no data has been transferred.( 10.122.210.17 is the IP Address of our RTU Controller) Whether WinCC Flex MODICON MODBUS TCP/IP Protocol only supports Schneider PLC or other PLCs as well? Do you have any Open MODBUS TCP/IP Driver? Herewith I have attached the screen shots of all the settings I have done in WINCC Flex & resulted error. Expecting your earnest reply Splitted from Modicon Modbus Driver. |
Last edited by: O_Moderator at: 12/2/2010 1:00 PMnew subject after splitting |
|
| 12/2/2010 1:02 PM | |
Joined: 4/24/2009 Last visit: 8/20/2024 Posts: 2682 Rating:
|
Thread closed, because question is already published in the following thread Do you have any Open MODBUS TCP/IP Driver?. Best regards O_Moderator |
Follow us on