Navigation

Problem running MB_Client

Created by: Lumirt at: 12/29/2020 3:21 PM (1 Replies)

12/29/2020 3:21 PM	Rate (0)
Lumirt Advanced Member Joined: 12/27/2018 Last visit: 9/3/2024 Posts: 4 Rating: (0)	Hi, I have a problem running the MB_CLIENT block which has something to send. If I manually modify the bit that starts the transmission, the transmission will be performed correctly. If I let this be done by application logic, the data will not be transferred. I noticed a strange behavior of the MB_CLIENT block for me. In the case of manual modification, the transfer takes 90ms (manual.png), when it is done, the application takes 45ms (program.png). Description: Network20: evaluates the difference and sets the bit to perform the preparation. Network21: sets variables and sets a bit to transfer data. Network22: MB_CLIENT is activated, resets bits after transmission. Could someone smarter explain this behavior to me, or alert me to where I'm making a mistake? Thank you for any help. Lumirt Attachment sample.zip (556 Downloads)

Suggestion To thank Quote Answer

2/23/2021 4:11 PM	Rate (0)
Duris_I Diamond Member Joined: 4/28/2015 Last visit: 10/30/2024 Posts: 10585 Rating: (825)	Ahoj, only very basic idea why that time delay. In case of communication usage (also for monitoring) I expect maybe delay due your set of Merker (start triger) later than existing comm block. In automatic system is all prepared and executed inside that block already with prepared new values to start, therefore no little delays logicaly. really not sure about other logical reasons. try do that manual tests again more times to see if they are similar with delayed time but I think is not important for you ;)
	Last edited by: Duris_I at: 02/23/2021 16:12:04 With best regards... Ivan Duris Flight: OMICO
Suggestion To thank Quote Answer