Hello.

I have used Siemens video to configure Technology object - Axis - for stepper motor with PUL, DIR, ENA connection. (implicit setting, Q0.0, Q0.1,Q0.2, common Vcc +24V; two end-stops simulated by I0.0 and I0.1) 

I have put only one function (MoveJog) in OB1, uploaded to S7-1200 and tried to test it in Commision.

After clicking first button to enter manual mode, it flash red in Axis error with timeout error. Everything else is gray and inactive.

Could you advice me any possible reasons for timeout error?

Thanx, Radek

Helllo,

after some study and diagnostic I can define ErrorID 16#860 and ErrorInfo 16#000B whitch  is strange compared to default configuration Im using.

Radek

Thank you.

I had to RESET the PLC to factory setting several times and now I can jog my stepper. 

Another problem is limited jog speed 1.56m/s - so I have to read and learn where to change this. 

Radek