Duris_I

Hello,

sry look at my definition name of Temp, I got it   #Temp1 f.ex. so in your case probably

#"Temp1".%X0   BUT pls, click on that writing to type again that text of your coil output and write it same as I wrote here on begining of Line   ->     #"Temp1".%X0     then ENTER.

Edit: at Jeff's post it looking like you want have it, but you must write that text with all as I said, then after ENTER it shows like in Jeff's post.

Edit3: pls consider that my Picture is only help that shows that you must type that writing as you see on Picture, you must type your name of writing!

 Ehm... what if instead of tia portal I'm using step 7 v.5.6?

------------------------------------------------------------------------------------------
Split from how to use bit in byte .

Then, you are in the wrong conference for talking about that feature.  It only applies to s7-1200/1500 PLCs which require TIA Portal.

There are different methods of accessing bits within bytes/words in S7-300/400.  If you search in the class step 7 conference for bits in a byte, you should find plenty of topics with the answer you seek.

smagliol

Duris_I

Hello,

sry look at my definition name of Temp, I got it   #Temp1 f.ex. so in your case probably

#"Temp1".%X0   BUT pls, click on that writing to type again that text of your coil output and write it same as I wrote here on begining of Line   ->     #"Temp1".%X0     then ENTER.

Edit: at Jeff's post it looking like you want have it, but you must write that text with all as I said, then after ENTER it shows like in Jeff's post.

Edit3: pls consider that my Picture is only help that shows that you must type that writing as you see on Picture, you must type your name of writing!

 Ehm... what if instead of tia portal I'm using step 7 v.5.6?