I'm using a M270B as a HMI. Ibackuped the program from HMI using prosave. Bu I cant open the file so I cant editing anything. What can I do toopen these kind of files? Do you know any program? Do I have to download any program to open them??

Hello zht,

It's impossible to make any changes in backup file made with Prosave. This file you can only restore in the same type of panel.

regards

Hello zht,

For this type panel you can use WinCC Flex or Protool. But... If you want to upload project and after that to change it, must have enabled the function "Enable backtransfer" for WinCC Flex and "Enable upload" for Protool, when you download project. This means that in the beginning you must have original project to enable this function, or if this has already enabled you can just try to upload with this softwares.

regards

Hello Umencho,

When I download th project, I couldnt see the ''Enable upload''optionin anywhere (download settings, options...etc) Also it didnt appear automatically when I want to download. So I coulndt choose it. Do you know where the''Enable upload''optionis ?
Regards,

Hazal

Hi,

You should go to file, download, preferences then you can find enable upload as UMENCHO said.

See the attachment.

Regards.

hi 

is there any producer  to do that i didn't  understand clear. 

Master$of$disaster

hi 

is there any producer  to do that i didn't  understand clear. 

 Hi,

Just see the picture shared from Arunakat1. Click on Enable upload, then click ok and start the download.