Hi May know how to RESET F30005 error. Its an double motor module. 

------------------------------------------------------------------------------------------
Split from sinamics s120 f30005 power unit overload I2t fault.

Hello,

this fault could be acknowledged immidiatelly as its cause dissapear.

If you have operator panel BOP20 on control unit, you can acknowledge displayed fault by pressing Fn button.

Or check acknowledgement signals of drive object, parameters p2103, p2104 or p2105, where they are connected. If it is to terminal, activate corresponding digital input. If it is linked to telegram (ack signal will be connected to PROFIdrive parameter), you have to activate this signal from PLC.

With regards

Martin