SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Fault F7410

6/2/2023 9:24 AM	Rate (0)
hmzdrh Posts: 2 Rating: (0)	I have a fault in S120 Power modul 6SL3320-1TE36-1AA3 the fault is F 7410 we have checked cable and motor all is Okey but the fault steel any help ??
hmzdrh Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

6/2/2023 5:56 PM	Rate (0)
Davinator Gold Member Joined: 1/4/2013 Last visit: 12/20/2025 Posts: 1195 Rating: (106)	Cause:The condition "I_act = 0 and Uq_set_1 longer than 16 ms at its limit" is present and can be caused by the following: - motor not connected or motor contactor open. - no DC link voltage present. - Motor Module defective. Remedy:- connect the motor or check the motor contactor. - check the DC link voltage (r0070). - check the Motor Module. https://support.industry.siemens.com/forum/it/en/posts/sinamic-s120-fault-7410/84550
	Searching for Siemens used/new equipments ? Take a look here : https://www.ravettiautomation.com
Suggestion To thank Quote Answer

6/5/2023 7:25 AM	Rate (0)
hmzdrh Posts: 2 Rating: (0)	I have do all this and all is okey but the fault is coming again
hmzdrh Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...