SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

SINUMERIK Konturs with mathematik

10/5/2024 8:26 AM	Rate (0)
ZusammenCo Joined: 10/4/2024 Last visit: 10/13/2024 Posts: 4 Rating: (0)	Re Good day, colleagues! There is the following task: It is necessary to describe the contour of the product after the end of the program (M30). In this case, you need to give the circuit a name and be able to call it for processing in cycles. I read in the literature that it is possible to describe some provisions as follows: EXAMPLE: G00 X0 Y=R1 ;Here is parametric variable G02 I-10 ;Simple tool traectory G00 Z+100 ENDLABEL: However, it turned out that this method does not work if the circuit goes after M30. Please advise with an example of spelling methods for describing and calling paths manually without SHOPTURN and SHOPMILL tools. I would be especially grateful if the example contains comments with explanations for dummies. Thank you for your attention and have a good day, colleagues!

Suggestion To thank

10/7/2024 7:34 AM	Rate (0)
Moderator_Lan Moderator Joined: 7/30/2024 Last visit: 11/11/2024 Posts: 319 Rating: (7)	Closed because posted twice. The active topic can be found here: SINUMERIK Konturs with mathematik Kind regards, Moderator_Lan

Suggestion To thank

Share this page:

Share this page on...