hi all

we installing 3 flow sensor SITRANS F M MAG 6000

but not sure such installation is recommended or not.

need help for some advice if we are doing not correctly

pipe size 4in

Thanks in advance 

danw

But, a couple years ago, Siemens did a flowstand test to qualify their 5100W water meter where either single or dual in-line or out-of-line 90° elbows at the inlet, the accuracy was within ±2% needed to qualify for municipal water service in Europe.   Siemens did not test the 3100 model or its other tubes, but magmeter technologies are so similar between models that I have to assume characteristeric inaccuracies are common between models.

 

 Attached document for flowstand test. It is applicable for 5100 & 8000.