I'm attempting to download HMI project to MP277 via Profibus which I have completed successfully many times without issue. This endeavor however has shown me some errors I have never seen. I have checked commnucations settings for both WinCC software as well as hardware which all look in order. I should note that device type was in correct from OEM, actual HMI hardware is MP277 but in WinCC OEM had PC and transfer settings of HMI were set to ethernet instead of Ethernet/MPI/DP.

I corrected the above settings and still have the error, "download cannot be performed. The created configuration is intended for a different device than currently connected"

Has anyone a solution please see attatchments

I'm attempting to download HMI project to MP277 via Profibus which I have completed successfully many times without issue. This endeavor however has shown me some errors I have never seen. I have checked commnucations settings for both WinCC software as well as hardware which all look in order. I should note that device type was in correct from OEM, actual HMI hardware is MP277 but in WinCC OEM had PC and transfer settings of HMI were set to ethernet instead of Ethernet/MPI/DP.

I corrected the above settings and still have the error, "download cannot be performed. The created configuration is intended for a different device than currently connected"

Has anyone a solution please see attatchments

The error result when transfer of project fails