Help! I have  discovered that my old logo boxes are obsolete,a nd I need to move over to 6ED1052-2MD08-0BA1

I have been given a memory chip that I used to plug into the top of the logo box to programme them. How do I now use an sd card? I.e. get the program off the chip onto an sd card?

The manufacturer of the machines have discontinued them now so I am left on my own

These logo boxes are being used in concrete crushers to control the hydraulics

I have no software or anything!

ixo65

The old memory cards are a problem as no PC or laptop has interfaces for them.

You can actually only get ahead with the current software.

You can use the software to download the program from the "old" LOGO! read out and transfer the program to the new LOGO! to adjust.

The program stores the device type for which the program is created.

 So, if I have a logo with the programme on, can i plug a  cable into it that will get me the programme, then transfer that to a sim card for the new logo boxes?

What software and cable will I need?

Digdugdan

 

ixo65

The old memory cards are a problem as no PC or laptop has interfaces for them.

You can actually only get ahead with the current software.

You can use the software to download the program from the "old" LOGO! read out and transfer the program to the new LOGO! to adjust.

The program stores the device type for which the program is created.

 So, if I have a logo with the programme on, can i plug a  cable into it that will get me the programme, then transfer that to a sim card for the new logo boxes?

What software and cable will I need?

 Use Logosoft serial cable original from Siemens. Or use Logosoft USB cable made by Chinese manufacturer is fine too. Logosoftware need to install USB driver software to make USB cable work also.