Hello,

hmmm looking perfect answer  in this case i'm capitulate, probably not helpfull to you  Give info if it was helpfull...

Subauto

Hello,

You can use "PAS_Command_Integer_V500(TagName,Value,value type,duration)".

You can find this command in  left pane in C Edit Action window  under : Project Functions > SicamPas > Command.

Parameters:

TagName : command Tag name with extension .value

Value: 1 for Open, 2 for close.

Value type: 15 for persistence command.

Duration: 1 , in second or what duration you want in seconds.

--------

create a button and in mouse event choose C action and insert:

If (condition ) true

PAS_Command_Integer_V500("Tag1.Value",2,15,1); // close (On) command

PAS_Command_Integer_V500("Tag2.Value",1,15,1); // open (Off) command

End

 Don't forget the double quotation (" ") before and after the tag name if you inserted it directly in the PAS_Command syntax .

For the message you can assign the command tag to alarm logging in Sicam PAS and choose Sicam Message for command tag in Alarm logging in Wincc. By this when you run the command in Wincc you see in the Event List positive confirmation if the command executed successfully and negative confirmation if command not executed successfully.

Or you can use Popup window for message .

 Thank you very much for your response. I will test it tomorrow and I will post the results!

Subauto

Hello,

You can use "PAS_Command_Integer_V500(TagName,Value,value type,duration)".

You can find this command in  left pane in C Edit Action window  under : Project Functions > SicamPas > Command.

Parameters:

TagName : command Tag name with extension .value

Value: 1 for Open, 2 for close.

Value type: 15 for persistence command.

Duration: 1 , in second or what duration you want in seconds.

--------

create a button and in mouse event choose C action and insert:

If (condition ) true

PAS_Command_Integer_V500("Tag1.Value",2,15,1); // close (On) command

PAS_Command_Integer_V500("Tag2.Value",1,15,1); // open (Off) command

End

 Don't forget the double quotation (" ") before and after the tag name if you inserted it directly in the PAS_Command syntax .

For the message you can assign the command tag to alarm logging in Sicam PAS and choose Sicam Message for command tag in Alarm logging in Wincc. By this when you run the command in Wincc you see in the Event List positive confirmation if the command executed successfully and negative confirmation if command not executed successfully.

Or you can use Popup window for message .

 Dear Subauto,

This worked perfectly! Thank you very much!