Navigation
Rating 
Thanks 0
3 Entries
| 5/9/2017 4:38 PM | |
|
Posts: 1 Rating:
|
i have cnc machine with sinumaric 802d contrller . when start machine error comming axis enable missing. i have check e/r 611 module enable led glowing its has attached three drive for 3 axis. drive showing in run mode. ------------------------------------------------------------------------------------------ |
Last edited by: Min_Moderator at: 5/10/2017 1:50:24 PMNew subject after splitting |
|
| 5/19/2017 12:14 PM | |
|
Posts: 8092 Rating:
|
Please check PLC logic for axis enable signals & not E/R module enable signal. |
| 6/29/2017 11:45 AM | |
Joined: 6/29/2017 Last visit: 12/25/2025 Posts: 7 Rating:
|
check PLC control word &status word. |
Follow us on