My answer is--it is possible.

I need you take picture of these 2 motor name plate --as I have no time to check manual --more important to know is the rate voltage (200V or 400V)

another point is --you need to modify the setting on the 611A control card , from picture--you have user-friendly interface card, you need change setting on the small parameter sub-module

If you have no 611A manual,  start now--Google --SIMODRIVE 611A start up guide  

acri

Good day,
first of all I am a newbie in the SIMODRIVE world, so maybe this could be a obvious question.

I am working with a machine that drives various motor with a SIMODRIVE 611 (6SN1145-1BA01-0BA1, I have attached a phot to the post), one of this motors, an 1FT5076-0AC71-1-Z, has been broken. We have in stock one 1FT50  motor with reference "1FT5074-1AC71-1AAC" (it is a little bit smaller, less Nm, but for normal operation it could be enought).

I would like to know if could I use the second one with the SIMODRIVE and if it would neccesary any change (change any parameter for example).

Thanks in advance