For Sinamics G150 Drive do all the Drive-Cliq connections e.g. between TM31 module, between CIM module and SMC30 module have to be configured in a certain way? 

Can I run cable from CIM X400 to CU320 X500 to TM31 X500 all in series or does each peripheral have to connect back to the CIM module via drive cliq cable individually?

Closed cause question posted twice.

The second thread with the subject Drive Cliq Connections is published within the conference SIMOTICS / MOTION-CONNECT.

Best regards,
Jen_Moderator
​