Hello,

Please refer function diagram 120 from SIMOVERT MASTERDRIVES Vector Control Compendium VC34 (Operating Instructions)  manual. Parameter p711 to p720 index 1 & p721 index 01 to 05 forms receive word PZD assuming 1 st communication board is configured for communication.

Hope this helps.  

Hi, P711 to P721 are 99% not used, only in special cases where the configuration of the CB card needs to be independently specified (i.e. Start up diagnostics, communications protocol to be used, PPO type etc)

To "VIEW" the received telegram (Words/PZD values), refer to r733 index 1 to x). Here, You can only see the raw data.

To understand the meaning of these, it is important to know & understand the structure of the telegram from the master.

Regards,

Graeme