Navigation

How to read the torque and temperature?

Created by: nbkbdnvdhvkjdmdlvmld at: 9/28/2021 12:55 PM (1 Replies)

9/28/2021 12:55 PM	Rate (0)
nbkbdnvdhvkjdmdlvmld Posts: 3 Rating: (0)	3dautomation Hello, I have a Siemens V90 Profinet driver. How can I read alarms on this drive via profinet? Under normal conditions I can read information such as torque, actual temperature, but I did not know how to read the alarm information. I'm glad you helped me. Thank you. Can you please tell me how have you read the torque and temperature.and if possible please send the program ------------------------------------------------------------------------------------------ Split from Sinamics V90 PN Alarm Reading.
nbkbdnvdhvkjdmdlvmld Posts: 3 Rating: (0)	Last edited by: Jen_Moderator at: 09/29/2021 08:04:21 New subject after splitting
Suggestion To thank Quote Answer

9/28/2021 8:03 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 11/8/2024 Posts: 5935 Rating: (815)	Hello, you can use Tel. 750. Then you get actual torque cyclic. SIEMENS additional telegrams (torque data) 7503) • Additive setpoint torque • High and low torque limits • Torque actual values Supplementary data Select the "Torque data" check box if you want to configure the data connection of the torque data. If you have selected a drive with which the additional telegram 750 has been configured, the "Torque data" check box is preselected. https://support.industry.siemens.com/cs/de/en/view/109781849
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer