6/21/2022 5:51 AM | |
Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating:
|
Hello IvanB., Alarm 701022 is not Siemens system alarm, but it is PLC alarm written & developed by OEM / machine builder. As such you need to refer machine manual supplied by OEM & find out probable reasons/remedies of 701022 alarm. If not, you need to have Simatic Manager Step 7 software with Siemens PG + MPI cable. With this hardware & software you can go on line with Siemens CNC controller & find out the reasons of 701022 alarm. Also you mentioned, you replaced one motor/encoder. Is it Siemens or Yaskawa make? Have you replaced it with same article number? Have you re-referenced the axis? Please check above points. |
6/24/2022 6:00 AM | |
Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating:
|
Please refer chapter 15 Reference point approach from SINUMERIK 840D sl/840Di sl/840D/840Di/810D, Basic Functions manual. Hope this helps. |
Last edited by: Jen_Moderator at: 06/24/2022 07:13:06Link optimized. |
|
This contribution was helpful to
1 thankful Users |
Follow us on